MONARCH ROPE
MONARCH ROPE

Rope End Termination Plate ANSI rated OSHA Approved CLIMBTECH

$46.95

Termination plates are used to connect a rope to something without the use of knots or factory terminations. This connector can be used with both Kernmantle rope between 7/16″and 3/4″ (11mm-19mm) and 5/8″ to 3/4″ (16mm-19mm) three strand rope. It is rated to 22kN or 5,000lbf and is priced right.

In stock (can be backordered)

UPC: MPN: CT MATP Categories: , . Brand:
ClimbTech

Product Description

The Rope End Termination Plate is designed to be used with Kernmantle rope between 7/16”and 3/4” (11mm-19mm) or 5/8” to 3/4” (16mm-19mm) three strand rope. Depending on the standards of the job site, termination plates may be required when factory rope terminations are not already present. End termination plates are an effective way to make compliant terminations.

Instruction Manual

Spec Sheet

FAQ

UTS 5,000-lbf
22kN Max User Weight 310-lbs
140kg Working Load 1000-lbs / 454kg

Do I need an end termination plate?
(A) Depending on the standards of the job site, termination plates may be required when factory rope terminations are not already present. ANSI Z359.1 states “Knots shall not be used for load bearing end terminations.” OSHA states that “Tie-off using a knot in a rope lanyard or lifeline (at any location) can reduce the lifeline or lanyard strength by 50 percent or more. The lanyard or lifeline should be replaced by one which has an appropriately incorporated connector to eliminate the need for a knot.” End termination plates are an effective way to make compliant terminations

Additional Information

Weight 7 lbs
Dimensions 18 x 12 x 12 in